How to use the display of my Pulse?
The Pulse controller is an integrated computer that controls your Pulse, its motor, the C961 display, the Pedaling Assist System (PAS), the accelerator, battery charging and more.
The main way to interact with the controller is by using the buttons on the left of your handlebars. This connects to the display in the middle of the handlebar, where you can see all your statistics, such as speed, battery charge, how far you've traveled, and more.
Using the buttons
Power button : Press and hold for about 3 seconds to turn on your Pulse.
Plus (+) Button : Whether stopped or while walking, press the (+) button to increase the Pedal Assist (SPA) level.
Minus (-) button : Whether stopped or while walking, press the (-) button to decrease the Pedal Assist (SPA) level.
Change date, time, speed measurement units, and screen brightness.
Step 1.
Press the power button on the pulse.
Step 2.
Press the + and – buttons together (long press).
Once the configuration mode is in, you can change between the parameters to be modified with the power button.
With this you will enter the configuration menu. On the first screen you can change the units of the speed measurement between Km/h and Miles/h.
The second screen will allow you to make adjustments to the speed limit with its LSPd signals, which has a maximum range of 50 in Ghost and Rebel models and 99 in Rebel X model, however, the speed is not reached with the engine with which the model counts.
The third screen will indicate the brightness level shown on the display, varying from 0 to 8.
The fourth screen will allow you to set the bike time.
When you finish making the settings, press the power button again to exit the configuration and settings menu.